FRP Asus Zenfone 3 Done

Waiting for device in fastboot mode ...

1. Power off device. Press and hold 'VOL DOWN' button
2. Insert USB cable, hold button until device will be found!

Connect Ok!

ADB activated!
- > Info : Wait till device boot, make offline setup until device show message about protection
- > Info : Re-connect cable, make "FRP Reset" in ADB tab!
Done!
Elapsed: 00:00:17
Operation : Reset FRP (ADB) [ v1.03 ]

Waiting for device in ADB mode ...

1. Connect device, enable 'DEVELOPER MODE' and 'USB DEBUG', if need!
2. Insert USB cable, accept AUTH on PhoneScreen, if software ask!

Device not found! Check cable, drivers and conection!

Operation : Identify (ADB) [ v1.03 ]

Waiting for device in ADB mode ...

1. Connect device, enable 'DEVELOPER MODE' and 'USB DEBUG', if need!
2. Insert USB cable, accept AUTH on PhoneScreen, if software ask!

Connect Ok!

Device Info :
Vendor : asus
Model : ASUS_Z017D
Device : WW_Phone
Android : 7.0
Product : ZE520KL
Brand : asus
Serial : G8AZCY10C6075NP
Build_tm : Tue Oct 3 11:17:16 CST 2017
DisplayID : NRD90M.WW_Phone-14.2020.1709.68-20171003
Patch Ver : NRD90M
SecPatch : 2017-09-01
Hardware : qcom
HW Board : msm8953
CPU rel : arm64-v8a
SIM Card : ABSENT,ABSENT
BaseBand : M3.10.47.3-Leo_080001
BaseBand : M3.10.47.3-Leo_080001
RIL ver : Qualcomm RIL 1.0
USB Conf : mtp
Sys USB : mtp,adb
FS Crypt : encrypted
Done!
Elapsed: 00:00:08
Operation : Reset FRP (ADB) [ v1.03 ]

Waiting for device in ADB mode ...

1. Connect device, enable 'DEVELOPER MODE' and 'USB DEBUG', if need!
2. Insert USB cable, accept AUTH on PhoneScreen, if software ask!

Connect Ok!

Device : WW_Phone
Model : ASUS_Z017D
FRP reset passed! Make FACTORY RESET from menu!
Done!
Elapsed: 00:00:04